Make-A-Clamp Kit

Make-A-Clamp KitThis is a maintenance clamp system in a box. By simply cutting off a piece of banding from a continuous roll, you can make any size 100% stainless steel worm gear clamp from 2" diameter on up (10 inch or 10 foot diameter, you pick it and you do it in fifteen seconds). Its a must for anyone whos likely to encounter requirements for varying sized large clamps. Reusable. Superior to and more versatile than crimp buckle banding and strapping products.

Cuts easily with a hack saw or band saw

Because it flares out (see below)

This silicone hump hose fits on Dodge Rams with the Cummins Engine

5" Fluid Compatibility Petrol

3-1/2" long

7/32 wall thickness

This basic kit for the GTO intake system has everything you need except the hole saw and air filter

This 7" 90-degree intake hose can be used any place you have two 7" OD tubes and you need to make a 90-degree bend

5" leg lengths

Fits most Ford throttle bodies and MAF's and adapts to standard 3" tubing

Five-ply reinforced silicone for high strength

2" OD welded 304 stainless steel tubing with a #4 finish and has