4" ID X 3.5" Long

4" ID X 3.5" LongThis straight coupler is useful when you don't have clearance for the "hump" of a standard hump hose. It's only disadvantage is the fact that it doesn't have the few degrees of flex that a hump hose has. Temp rated at 250 275F. Made in USA. Recommended clamps are 94100 0450. S400X350

NOTE: This hose is a bit thicker than other 3" hoses and requires a slightly bigger clamp

Handles 350 F continuous and is perfect for intercooler/aftercooler and turbocharger applications

This 90 degree silicone elbow is 4" ID on one end and 2-1/2" ID on the other and can be used anyplace you need a reducing 90-degree bend

Four-ply poly reinforced silicone

Actual ID is 3

You install it in the end of the 2" rubber elbow or hump hose

This 5 inch to 4 inch reducing silicone coupler is 3 inches long

Recommended clamps are 94100-0475 on the small end and 94100-0550 on the big end

2" OD welded 304 stainless steel tubing with a #4 finish and has

This standard 3" 90-degree intake hose can be used where have two 3" OD tubes and you need to make a 90-degree bend

Recommended clamps are the 9424H

5" ID intake hose to a 4" OD tube