Z3M BMW SLR Race Kit Control Arms (Circuit Use)

Z3M BMW SLR Race Kit Control Arms (Circuit Use)Please note, our race kits do not add steering angle, and often will reduce steering clearance slightly because they are designed with a delta shape in place of the L shape factory arms to provide a stronger arm with direct load paths for minimum weight. Lightweight tubular high strength control arm set, including matched Billet 7075 T6 Aluminum roll center, bump steer and quick steering geometry plates. Each control arm is 100% TIG welded in house by

FK 3/4 spherical bearings

MXG-Strada 7 Inch Driver Display From Link

Very easy access to all the nuts to reduce install time

0L commonly found in the 2013+ Escape and Focus ST

unused fuel and ignition drives can be used as additional Aux outputs

*NOTE: This product has only not been verified to fit RHD cars*

The ultra-low rotating mass of our unique bearing and shaft assembly is matched to aggressive compressor aerodynamics to ensure high levels of performance at lower shaft speeds which is mated with a unique turbine wheel to ensure power at high loads and flow is maintained

as well as increasing reliability and protecting your critical components from damage

mandrel bent piping (60

and a strong rare-earth magnet combine to deliver unmatched performance and protection

designed to maximize the potential from your car

These super thick and durable 3mm aluminum anodized toe plates allow you to adjust your toe-in or toe-out from either outside or from under your car where you can turn your tape measure sideways