Holybro PixHawk PM06D-14S Power Module (15020)

Holybro PixHawk PM06D-14S Power Module (15020)Holybro PixHawk PM06D 14S Power Module (15020) Description PM06D provides regulated power supply for your Pixhawk 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built in power distribution, allowing you power your ESC and FC with the same board. The on board switching regulator outputs 5. 2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely

which have been widely used for over a decade

The NEO form factor allows easy migration from previous NEO generations

Please charge the LED light with special balance charger for lithium battery

Mini Cable Set (18083)

and Galileo (E1/E5a/E5b/E6)

0 or newer is required

2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable

Support PWM/SBUS signal output

providing the easiest ways to setup a telemetry connection between your Autopilot and a ground station

Holybro Digital Air Speed Sensor - MS5525DO / PT60 Pitot Tube (19011)

* The detection range depends on many factors such as the receiver antenna gain

Quick Start Guide