8mm Keder Leader Set (1L/1R)

8mm Keder Leader Set (1L/1R)The 8mm Keder Leader Set is utilized to reduce the wear and tear on the leading keder edge of kedered roof panels that use 8mm keder. These locations often receive the brunt of the damage during installation and the Keder Leader is designed to take the wear and tear and be replaced rather than repairing or replacing keder of the primary roof panel. Used on the following products: Tectrac SK Minibeam

Where traditional strap and buckles tend to deflect the tent top downward near the eave

It is used on all sizes from Festival CAN-W frame tents from 10' wide up to 20' wide

25" SCH 40 pipe are 1

Hi-Viz  case is easy to find on the job site

This is the side fitting for the Festival frame tent design

and a swaged top to fit into the bottom of the upper pole section

This slide fitting can be used for a variety of applications including adding extra legs in between two existing legs

4-point suspension with vertical height adjustment assures a personal

The JackJaw 302 can pull stakes driven with 6" remaining above ground

This 2pc 4" OD aluminum lighter weight pole is split for ease of transport

750" OD 6061-T6 Structural Aluminum Tube

25" SCH40 steel and welded to a 4" x 8" x 1/4" steel plate