Sharp GP2Y0A710K Distance Sensor (100-550cm)

Sharp GP2Y0A710K Distance Sensor (100-550cm)The GP2Y0A710K infrared sensor is a new version of GP2Y0A700K which takes a continuous distance reading and reports the distance as an analog voltage with a distance range of 1m (39. 3") to 5. 5m (216. 5"). The interface is 5 wire JST connector (included with pins) with dual Vcc, dual Gnd, and a single output voltage. Power, ground and signal wiring is enough to read a continuous analog voltage representing distance. A software lookup table can be

1") XHP-2 housing  x20

4 x candle flicker LEDs - they twinkle automatically

5" (120mm) long

and is used to bond two conductive surfaces together and allow a small (we'd say keep it under 100mA) current to flow through the tape

1x   Thread Drive Beam

The plate uses the high speed SPI interface on the Pi and can use the mini display as a console

and is a great way to get started sewing electronics

Most converters we've found are not very easy to use

Dimensions: 53mm x 69mm x 3mm / 2

a CR1220 coin cell holder to keep the RTC running and allow warm starts and a tiny bright red LED

it detects Methane

Mega Prototyping Shield for Arduino Mega    x1