Pan-Tilt HAT for Raspberry Pi and Jetson Nano

Pan-Tilt HAT for Raspberry Pi and Jetson NanoNOTE: This product compatible with Raspberry Pi 3 Model B+, Raspberry Pi 4 Model B, and Jetson Nano. Not compatible with Raspberry Pi 400, Raspberry Pi Pico and Raspberry Pi Compute Module 4. This is a 2 DOF pan tilt hat based on Raspberry Pi 40PIN GPIO. It can directly be used once plugged into the Pi boards GPIO. Meanwhile, the board makes the Raspberry Pi GPIO pins led out for your convenient use. With the I2C interface adopted, the module allows

If your K-type thermocouple is obtained from other places

Xadow Basic Sensors

It is based on the Atmel ATSAMW25 SoC (System on Chip)

The module should avoid being placed in the volatile silicon compound steam

On-board STEMMA QT connector that lets you quickly connect any Qwiic

AMG8833 GridEye and FeatherWing TFT

which means it has tons of room for goodies

This OLED uses the SSD1351 driver chip

We've tested this with all our ItsyBitsy and it should work just fine with them except the ItsyBitsy 32u4 5V (because the voltage is not right)

now pre-assembled

Xiaomi Note2

025 ohm resistor in line with the power pin that is used to measure current draw