HamGeek 100K - 180MHz K-180WLA New Active Radio Shortwave Antenna Full Wave Band SDR LOOP Antenna with 10m Feeder

HamGeek 100K - 180MHz K-180WLA New Active Radio Shortwave Antenna Full Wave Band SDR LOOP Antenna with 10m FeederDescription: The K 180WLA enhanced version has a small ring with a diameter of 68CM and a low battery indicator is added. The 2023 new version of the preamplifier has replaced the imported RF amplifier with better parameters and lower noise figure (non low end video amplifier IC), higher receiving dynamics and signal to noise ratio, lower noise figure, and can withstand 10DBM signal strength Unsaturated, the feeder is upgraded to LMR100 96 braided

* The applicable frequency standing wave ratio must not exceed 1

IQ modulation (Only using 1 transmitting and 1 receiving for hardware)

- All use industrial-grade chips and support a temperature range of -40 to 85°C

- Migration for FMCOMMS3 firmware

and you need to use several software to try)

- Interface: SO-239 (M female)

- It is forbidden to use it to directly test the unknown antenna standing wave

after calibration

A single-board design combining FPGA and CPU ensures lower power consumption

The tuner uses a larger LED lens and is mounted on a PCB

do not shorten the length according to the pull rod

It should be noted that please turn off the power supply of the radio and antenna tuner before plugging in the data cable