Jumbotrac JT1 10'6"

Jumbotrac JT1 10'6"This kedered aluminum tubing is used as a rafter in the Jumbotrac 50' wide frame tent system on the hip end only. Each length of tubing is drilled with parallel 7 16" diameter through holes located 3" from each end of the extrusion for connection to a 3 8" Diam. push button and an additional 9 16" holes for connection of braces. Specifications: Base Material: 4. 65" x 2. 06" JT1 Extrusion 6061 T6 Structural Aluminum Tubing, ID 1. 750", OD 2. 06", and

Commonly it is used on a 10'x20' frame tent where a single ridge pipe is used rather than two shorter rige pipes and a traditional top tee fitting

50% Polyester

This 1pc 4" OD aluminum lighter weight pole is a continious pole section

allow for complete 360 degree rotation of the flag even when the wind direction changes

This fitting is the "left" fitting when looking from the outside of the tent

Clamp is engineered for a 375lb hanging load utilizing a minimum safety factor for allowable load of 5:1

Perpendicular to ground

Loose 10' long webbing end is constructed of high tensile polyester webbing and sewn to a 1" Snap Hook

Base Material: Stainless Steel

(1) Festival Mast Adj 20x

25% Cotton & 25% Rayon

This cable is used on both 10'x10' and 10'x10' expansion modules of the Festival CAN-T frame tent systems