GEO5 Sheeting Design

GEO5 Sheeting DesignThis program is used for a quick design of non anchored walls and to make a preliminary design of anchored retaining walls (Sheet pile, Soldier pile, Diaphragm, and Pile walls). The results show the required embedment lengths, the internal forces on the structure, and the forces in anchors. The sheet piles can address reinforced concrete, steel, or timber cross sections. Advanced analysis of multiplied anchored walls, including displacement of

It provides pre-defined log templates as well as the ability to create user-defined templates/reports

sheet pile/diaphragm walls

This program computes earth pressures acting upon an arbitrarily shaped structure active pressure

This program is used for the analysis and design of bridge abutments including wing walls

This program is used for the design of cantilever retaining walls

and subsurface modeling

This program is used to design soil nail walls and slopes of various shapes with shotcrete cover or steel mesh

The initial analysis should be done in the Slope Stability program

Both floating piles and piles fixed into subsoil can be analyzed

This program is used to analyze the stability of rock slopes and walls for a specified type of failure

This program is used for the design of pile walls stabilizing slope movement or increasing the safety factor of the slope

slope stability