Gravity: LED Button x 5 Pack

Gravity: LED Button x 5 PackThis is a simple LED illuminated switch button. Its just like a common switch button but lights up different colors(red yellow green blue white) when pressed down, which gives us visual feedback. These little buttons can be used with controllers like micro: bit, Arduino, etc., to realize various fun interactive projects. This is a digital button switch with an LED light display. Experimental Cases Supports programming platforms like MakeCode, Mind+

This wire is 500 cm long which is the maximum that can be driven by our handy 2xAA portable pocket inverter The full length draws 200mA from the 2xAA batteries (so 2000mAh batteries will last ~10 hours if on 'constant' mode)

Extra 6mm (0

add demo codes or tutorials

They are for indoor use or light outdoor use without direct sun/water

so you can plug right into a solderless breadboard

The software library adopts the two-point calibration method

This is just the basic version of our Perma-Proto HAT

and capabilities

-ESP32-E cannot use an expansion board for ESP32 V4

18 sets of header pins for connecting 3 pin hobby servos

Gallery: Gallery and Lessons

Deviation:2