QT1060 Taper Wedge Remover

QT1060 Taper Wedge RemoverDiscontinued. QT1060 Taper Wedge Remover is a specialized plier that makes removing the split, tapered axle shaft stud cones from rear axle shafts quick and easy. The wedge shaped upper jaw fits into the wedge slot. Squeezing the handles expands the wedge making it easy to pull out. Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your

ram 3500: TS4620

Also can use flat side to install Dodge 4x4 Rear Output Seal Countershaft Front Bearing Installer QT2004 Can also use to press 3-4 Synchro Hub on original equipment mainshafts Input Bearing & Countershaft Rear Bearing Installer QT2005 Can also use to install Input Seal Input Bearing Cup Installer QT1801 Use with QT1100

QT1042 adjustable depth installer allows you to offset the seal to miss a worn spot on the axle shaft

gives us the confidence to supply our QuadTools to anybody

Gasket: TK30052

Input Shaft End-Play on direct mount models and rear output shaft end-play on 1980-1991 GM units with slip yokes is minimized by the use of selective fit snap rings

Full Float Model 60 or Model 70 Rear Axles equipped with TK4000 Spindle Nut Upgrade Kit: 1979

and Dana 50IFS front/rear drive axles or other applications that require installing bearings with 1-5/16" to 1-3/8" inside diameters on long shafts

QU50186 Manual Hub Lock Body

check for broken motor mounts

21" diameter) Tech Note 7: NV4500 Tools

Full Size Chevy Blazer and GMC Jimmy: 1977-1/2