2.8\" TFT Display with Resistive Touchscreen

2.8\" TFT Display with Resistive TouchscreenThis is a screen for advanced hackers who like the look of the TFT screen we've put into the PiTFT, TFT shield v2 and 2. 8" TFT breakout. This display has 320x240 pixels and is driven with the ILI9341 chipset. This is just the display module! No PCB is included! You can talk to this chip with SPI (4 or 3 wire), 8 bit parallel, or 16 bit parallel. It also can be put into "dot clock mode" for raw TTL signal in but we have never done this ourselves so

5mA(sleep mode)

64 LEDs light up to tell you the time in a variety of ways

Protrudes from edge of Raspberry Pi 8mm when installed

BzzzzzBBzzzzzBzZZZzz

simply connect any micro B USB cable (not included) into the sensor and install the FTDI drivers to get serial sonar distance data via serial on any computer operating system

Side A slim PCB X4

org Its features are intentionally limited

Attention: If using Base Shield v2 with Seeeduino V3

2018 this item now includes a stencil

SPI or UART

no need for soldering or breadboards: plug in your Grove sensors and start programming directly

And the hardest part about not killing your houseplant