Breakout Card Type2 Spring Loaded 22-18 AWG for Raspberry Pi

Breakout Card Type2 Spring Loaded 22-18 AWG for Raspberry PiOverview The Breakout Card Type 2 Spring Loaded plugs into a Raspberry Pi 40 pin GPIO header, bringing all the GPIO pins out to spring loaded terminal blocks for fast, tool free wiring. 3. 5mm Pitch PCB Spring loaded Terminal Block Connectors Stainless steel wire guard Phosphor bronze, tin plated pin header Rated 5A 300V, accepts 2218 AWG wire 3D STEP model available INTERFACES AND I O I O's Communication Software Integration All Raspberry Pi GPIO

The HALL Current Sensor DAQ HAT provides eight non-intrusive current measurement channels for Raspberry Pi

Sequent Microsystems Opens Funding for the Smart Fan

Wire your project into the spring-loaded terminal blocks (22–18 AWG wire)

Any combination of HOP cards can be installed on the same Back Panel

Board Layout

lower cost

each input is opto‑isolated from system ground

The next four positions select each port as RS232 or RS485

Eight Analog Outputs: Positive side of 4-20mA or 0-10V is routed to the odd number I/O's

The Raspberry Pi sits in the dedicated slot on one panel and communicates with all HOP cards across all linked panels via CAN and RS485

Only the normally-open contacts are brought to the connectors to maximize perimeter space

for Raspberry Pi