7' 8" - Jumbo Pipe

7' 8" - Jumbo PipeThis 2" x 4" Custom aluminum extrusion is commonly used in frame supported tent systems. Each length of tubing is drilled with parallel 5 16" diameter through holes located 3" from each end of the extrusion. Specifications: Base Material: 2" x 4" Custom 6061 T6 Structural Aluminum Extrusion, with a 0. 125" wall thickness Finish: Anodized Commercial Clear

This is the corner fitting for the Festival CAN-W frame tent design

This 1pc 4" OD aluminum lighter weight pole is a continious pole section

The bottom adjustable mast fitting is constructed of aluminum and zinc plated steel and features a milled steel rolling wheel that slides easily on the cross cables of this frame system

Designed to hold up to 36pc of 1

Each of the two (2) pullropes included in the set features a snap hook braided on one end and the open end is back braided to prevent unraveling

The benefit to using the Mid-Span Tensioner rather than just a strap and buckle comes in the angle of pull of the strap against the eave pipe member

400lb breaking strength

polyester brow pad helps keep sweat out of wearer

The top pin is a zinc plated welded steel assembly with a 0

Be sure to properly align these angles into the proper orientation

The mast cap assembly is supplied with a 1/4" Acadapin to fasten to the bottom of the mast assembly

a 4' mid section