TS1248 Combo Ball Joint Press Adapter Set for Ford F450, F550 & GM C4500, C5500

TS1248 Combo Ball Joint Press Adapter Set for Ford F450, F550 & GM C4500, C5500TS1248 8 Piece Combo Ford GM Ball Joint Press Adapter Set Only for 2005 2016 Ford F450, F550 2005 2009 Chevy Kodiak and GMC Top Kick C4500, C5500 4x4 Chassis Cab Trucks to replace factory and most aftermarket Ball Joints. The Dana Super 60 (Ford) or Super 70 (GM) front axles on these Heavy Duty trucks have big ball joints that are tightly pressed into the steering knuckles. Our TS1248 Ball Joint Tool Set is the safest and most efficient way to replace

Matching parts for QU40166 Inner Spindle Nut in 1985-1997 F350 Dana 60 Front Axles with Manual Hubs or 5 Bolt Cap Auto Hubs

F350 Super Duty® axle shaft to knuckle seals are of a complicated unitized design that is easily damaged without the correct installer

F-Series with Borg Warner 1356 transfer case and standard two joint front driveshaft (no CV): 1987

75" rear axles and some 2011

cast iron 3rd Gear Thrust Washer used in the NV4500 transmission should be replaced if there is ANY evidence of wear on the thrust face

W200: 1975-1980

Remote Mount NP205 Transfer Cases: 1969

Tech Note 1: Replace Cup and Cone

verify you have a 1-1/4" outside diameter slip stub with 16 full length splines and a slip yoke that uses a press on seal

bearing supported mainshaft 3rd gear that is ONLY compatible with 1992-1994 GM New Venture NV4500 5 speed manual transmissions with 6

Dana 28IFS 1995-1997 Ranger w/ABS BOM 610484

1/2 ton 4x4s with front drum brakes: 1969