Amana Tool 45750 Carbide Tipped V-Groove 90 Deg x 1/2 Dia x 1/4 x 1/4 Inch Shank with Upper BB

Amana Tool 45750 Carbide Tipped V-Groove 90 Deg x 1/2 Dia x 1/4 x 1/4 Inch Shank with Upper BBDesigned for fluting and V grooving cuts guided by a template or pattern. The shank mounted ball bearing pilot rides along the template edge, and the cutter duplicates the template contour in the workpiece. With a handheld router, the template must be on top of the workpiece. With a table mounted router, the template must be on bottom of the workpiece. 90 V Groove bit is for decorative purposes and is not intended for miter folding, etc.

Cross cuts with the FSK cross-cutting guide rail (floor panels

The deep guide collar design adds stability to the tool for hand-held router operations

Designed with a maintenance-free motor

rather than a full 180° radius flute

The result is a tool that combines the speed and chip clearance of a one-flute bit with the strength and balance of a two-flute bit

Switch from fluting to beading by raising or lowering the bit

Get the practicality and productivity of an insert bit for the cost of a standard brazed-tip bit

maintain the same high level of functionality while allowing the user to bring the jigsaw to some rather inconvenient places for corded jigsaws

The tool is shouldered to cut a fillet

it shears down on both surfaces at the same time

use these large-diameter flush trim bits on a standard router

In cases where the carbide tip cutting edges are coated