AM2302 (wired DHT22) temperature-humidity sensor

AM2302 (wired DHT22) temperature-humidity sensorThe AM2302 is a wired version of the DHT22, in a large plastic body. It is a basic, low cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2

This module can be easily connected directly to Xadow Main board to display and record the above-mentioned information

check out our RGB LEDs that you can easily control with a microcontroller We also have a version that's an exciting RGB flashing pattern

Double H driver module uses ST L298N dual full-bridge driver

the battery will slowly drain since the charge rate is less than the dis-charge rate

works with any 3mm LEDs and eight tiles can be tiled together on a shared I2C bus

there are 13 Grove connects

Connection method - CAGE CLAMP® CONNECTION

Comes as a single flex PCB per order

See the ADXL377 webpage for datasheets and more

internal speed-of-sound temperature compensation and optional external speed-of-sound temperature compensation

which you also likely have

IO port input voltage: -0