Gravity: Analog Voltage Divider V2

Gravity: Analog Voltage Divider V2The Analog Voltage Divider V2 can detect the supply voltage from 0. 0245V to 25V. This module is based on resistor divider principle. The voltage detection module allows the input voltage to reduce 5 times. As the Arduino analog input voltage is normally maximum 5V, the input voltage of analog voltage detection module can not exceed 5Vx5 which is 25V. Notice: The new version of analog sensor port pin mapping has been changed as the following two

all of the the LED driver chips

Some soldering is required to assemble the HDC1008 sensor

Until Feb 4

This is a brief introduction into how you can use Electric Paint to cold solder components and create circuits in parallel and series

use a Pi 3

} Your power supply problems just got SUPER SOLVED

Digital two wire (I2C) interface

and additional GPIO pins

You'll need a soldering iron

The electronic kit comes unassembled with all electronic components

2'TFT Display Module character number 320×240 screen scale 2

Interface:Digital Output