Wall mount for EGO 56V hedge trimmer HT2400/HT2500

Wall mount for EGO 56V hedge trimmer HT2400/HT2500I designed this wall hook for the 56V EGO hedge trimmer to save shelf space and securely hold the trimmer against the wall. Tested with the HT2410 and HT2500. This hedge trimmer hook is 3D printed (FDM) using durable PET G (polyethylene terephthalate glycol, a. k. a. polyester). I recommend securing the hook with at least one screw into a wall stud or other wood backing to handle the stress of repeated loading unloading of the hedge trimmer. Use all

After much development

or place something under the chainsaw

This mount is designed to hold three Kobalt 40v batteries for lawn equipment

The open design of the mount allows for easier removal of the battery while keeping it securely in place

Fixtures may vary slightly in color from pictures depending on available source materials

I recommend securing the hook with at least one screw into a wall stud or other wood backing to handle the stress of repeated loading/unloading of the blower

This trimmer rack is 3D printed (FDM) using durable PET-G (polyethylene terephthalate glycol

Note: Chain oil may drip

I used 2x 3 inch countersunk deck screws into the wall stud and 2x #6-32x1-3/4in hollow wall anchors for the other two screw holes for these photos

Disclaimers:

This battery mount is 3D printed (FDM) using durable and non-toxic PLA

Disclaimers:Hand tighten screws