DC-DC Multi-output Buck Converter (3.3V/5V/9V/12V)

DC-DC Multi-output Buck Converter (3.3V/5V/9V/12V)Multiple output DCDC converters are essential in a multitude of applications where different DC output voltages are required. This DC DC step down voltage power module converts 7. 5V~30V input to an output of 3. 3V 5V 9V 12V (default to 5V), which can be selected by short circuiting the corresponding pads on the back. It withstands up to 5A load current with suitable heat dissipation and has 70 over temperature and overload protections. Besides, there

Note it is not a boost or buck converter - if the power supply only can do 5V or 12V it will not magically convert it to 20V - we do have USB booster cables if that's what you want

To wire up these strips we suggest picking up some JST SM plug and receptacle cables for the signal wires

Directly plug the module to the Raspberry Pi GPIO port for use

This is a great second project after you've mastered the Starter Pack  or ARDX and there's lot more info on the DIY Gamer Kit's website

Runs for about 8 hours continuously on two CR2032's

50W-300W passive speakers

Interface: TTL Serial

Board-Overview

WS and Data lines but having one with Select to ground

but no battery or power plug

The communication protocol is I2C so it uses only 2 pins

Historically it's been used in nautical navigation to aviation to radio