2.7'' Triple-Color E-Ink Display for Raspberry Pi

2.7'' Triple-Color E-Ink Display for Raspberry PiThis module is high contrast, wide viewing angle triple color e ink Display for Raspberry Pi. The e ink screen can customize the picture when it is powered on, the picture will not disappear after power off, and it can be displayed for a long time. The display area of this module is 2. 7 inches which contains 264x176 pixels. Each pixel can display red, white and black. E ink screen also known as E paper screen has lots of advantages compared with

56MHz RFID/NFC reader but make sure it can handle ISO/IEC 14443 Type A cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino

whether you’re just starting out with circuits or creating complex interactive artworks

The hall-effect sensor outputs the corresponding pulse signal

000 times so you don't have to worry too much about wear leveling

2 (interrupt 1)

the DigiLab 3D45 offers the new "Dremel DigiLab 3D Slicer" software for convenient and intuitive preparation of the print file

And MOSFET supports quick ON-OFF switch

They're now FTDI-chip based for better performance and reliability

Water Turbine Generator and other sensors

The sparking sense set has our favorite sensing switches and we walk you through how to build gadgets with each one

Laser source CO2

Full 3D position data and gesture information (swipes