1996-2002 3rd Gen 4Runner Panhard Correction Kit (PCK)®

1996-2002 3rd Gen 4Runner Panhard Correction Kit (PCK)®The Original PCK Weld on bracket kits to correct the Panhard bar angle on 2 4. 5" of lift. The Panhard Correction Kit returns the panhard bar to horizontal (per the original design), eliminates the need for an aftermarket adjustable panhard bar to recenter the axle, and, in most cases (up to 4 inches of lift), raises the roll center for improved handling (a 4 4. 5 inch lift maintains the roll center of an adjustable panhard). The lift bracket raises

stock hole on the frame side

Over time and hard use

A – The bumper components are pre-bent

We knew the receiver pin access needed to be from the top side and the receiver had to be completely encased in the rear face of the bumper to maximize departure angle

first a 50mm lift to get the travel benefit of longer shocks and springs

Q – You recommend running Sonoran Steel’s upgraded body mounts to avoid bumper flex into the body

A single upper reinforcement that ties the forged ball joint arm directly to the bump stop mount to create a direct load path in order to reduce flexing at the end of the factory arm

A – It requires my rear crossmember

Seems like you made the curvature in the bumper to accommodate the plastic trim

we designed a system of reinforcement plates to combat cracking from hard & repeated upward compression

You will need to cut out the pinch weld in the rear of the wheel well on each side

but I’ll include instructions on how & where to trim them