SparkFun MicroView - USB Programmer Arduino, Other, Sparkfun Originals

SparkFun MicroView - USB Programmer Arduino, Other, Sparkfun OriginalsThe MicroView is the first chip sized Arduino compatible module that lets you see what your Arduino is thinking using a built in OLED display. This USB programmer connects directly to the MicroView and lets you not only program the module, but use it to interface with your computer, Rapsberry Pi, or other USB device. The programmer has both male and female headers which allow it to be plugged into a MicroView module and a breadboard at the same time,

94") of building space for through-hole components with 2

you can provide an environment with optimal temperature for your fish

these have two hooks that are capable of grabbing very small points (like SOIC IC legs)

Quickly attaches to the front of your camera lens

This allows us to use the SparkFun LPC2148 USB bootloader for even easier and faster modification of the firmware

This is due to the RFID being sensitive to heat and should be handled with care or if you would like to switch the readers out as you please

Once sewn into your project just attach your favorite XBee to the pre-soldered headers and you are good to go

If you are asking yourself “What sorcery is this

Dimensions: 20mm x 11mm

Well this clear bread board might enlighten

The benchtop power board kit was created to provide quick access to the typical voltages needed when developing physical computing projects (embedded systems)

however there are 5 bare pads you can solder to