Solder:Time Desk Clock

Solder:Time Desk ClockMake a sleek full featured, conversation starting desk clock. The Solder: Time Desk Clock is the latest addition to the Solder: Time kit family. The Solder Time Desk Clock (STDC) is a DIY soldering kit. You only need to provide some basic electronics tools; Solder iron, solder, screwdriver, some fine grit sandpaper and wire snips. We've pre programmed the chip, so it's ready to roll once assembled. Itching to hack in some custom code or hardware?

returning any output

The reason that two 3V coin cells can be used to drive LEDs with a forward voltage of about 3

but here's how to give him a voice transplant and add your own fun sounds to this talking mask

• nRF51-01

We use these handy cables all over our factory and homes

easily replaceable)

This is the Chibitronics Color LEDs Add-on Pack

These are the "straight" style - the wires go in from the top

If you need to have an RGB perform a particular arrangement

3V (Output high when motion detected)

this little lipo charger is so small and easy to use you can keep it on your desk or mount it easily into any project

We put this nice chip onto a breakout board